Find the best tutors and institutes for Class 9 Tuition
Q17:
Explain how defects in a metal block can be detected using ultrasound.
Solution :
Step 1: Theoretical Foundation of Ultrasonic Flaw Detection
The detection of internal defects in metal blocks relies on the principle of ultrasonic reflection. Sound waves with frequencies greater than $20,000 \text{ Hz}$ (ultrasound) are used because they possess short wavelengths, allowing them to travel through solid media with minimal diffraction, thereby enabling high resolution [Per the wave properties of high-frequency sound].
Step 2: Experimental Setup and Procedure
To detect a defect, an ultrasonic transmitter (transducer) is placed on one surface of the metal block. A coupling medium, such as oil or grease, is applied between the transducer and the metal surface to eliminate air gaps, which would otherwise reflect the sound waves due to impedance mismatch [Per the principle of Acoustic Impedance Matching].
Step 3: Signal Analysis and Defect Localization
The detection process follows these logical steps:
- Emission: The transducer sends a high-frequency ultrasonic pulse into the block.
- Propagation: If the metal block is homogeneous and free of internal flaws, the ultrasonic waves will travel through the entire thickness and reflect only from the opposite side (the back wall).
- Reflection: If there is a crack, air bubble, or porosity within the block, the ultrasonic waves hit the interface between the metal and the void. Since the acoustic impedance of the void is significantly different from that of the metal, a portion of the wave is reflected back to the surface [Per the Fresnel reflection coefficient equation: $R = \left( \frac{Z_2 - Z_1}{Z_2 + Z_1} \right)^2$].
- Detection: The transducer (acting as a receiver) detects these reflected pulses (echoes) and converts them into electrical signals.
Step 4: Interpreting the Echo Patterns
By measuring the time $t$ taken for the pulse to travel from the transmitter to the defect and back, the depth $d$ of the defect can be calculated using the following formula:
$$d = \frac{v \times t}{2}$$
Where:
| $d$ | = depth of the flaw from the surface |
| $v$ | = velocity of sound in the specific metal |
| $t$ | = total time elapsed between the transmission and the receipt of the reflected echo |
The factor of $2$ is included because the pulse travels the distance to the defect and back to the surface [Per the law of wave reflection].
Final Solution: Defects in a metal block are identified when ultrasonic waves reflect prematurely due to an interface with a flaw (like a crack or void), resulting in an echo signal on an oscilloscope that indicates the precise location and size of the defect based on the time-of-flight calculation.
More Questions from Class 9 Science Sound Exercises
- Q1: What is sound and how is it produced?
- Q2: Describe with the help of a diagram, how compressions and rarefactions are produced in air near a source of sound.
- Q3: Why is sound wave called a longitudinal wave?
- Q4: Which characteristic of the sound helps you to identify your friend by his voice while sitting with others in a dark room?
- Q5: Flash and thunder are produced simultaneously. But thunder is heard a few seconds after the flash is seen, why?
- Q6: A person has a hearing range from $20$ Hz to $20$ kHz. What are the typical wavelengths of sound waves in air corresponding to these two frequencies? Take the speed of sound in air as $344$ m s$^{-1}$.
- Q7: Two children are at opposite ends of an aluminium rod. One strikes the end of the rod with a stone. Find the ratio of times taken by the sound wave in air and in aluminium to reach the second child.
- Q8: The frequency of a source of sound is $100$ Hz. How many times does it vibrate in a minute?
- Q9: Does sound follow the same laws of reflection as light does? Explain.
- Q10: When a sound is reflected from a distant object, an echo is produced. Let the distance between the reflecting surface and the source of sound production remains the same. Do you hear echo sound on a hotter day?
- Q11: Give two practical applications of reflection of sound waves.
- Q12: A stone is dropped from the top of a tower $500$ m high into a pond of water at the base of the tower. When is the splash heard at the top? Given, $g = 10$ m s$^{-2}$ and speed of sound = $340$ m s$^{-1}$.
- Q13: A sound wave travels at a speed of $339$ m s$^{-1}$. If its wavelength is $1.5$ cm, what is the frequency of the wave? Will it be audible?
- Q14: What is reverberation? How can it be reduced?
- Q15: What is loudness of sound? What factors does it depend on?
- Q16: How is ultrasound used for cleaning?
CBSE Solutions for Class 9 Science Sound
Chapters in CBSE - Class 9 Science
Top Tutors who teach Sound
I am experienced, qualified home tutor with 3 years of experience in teaching maths and science of CBSE board. Passionate about solving mathematical problems and understand science around us. Over the years I have helped many student to overcome their fear of maths and science.
I loved her teaching. She makes the students understand things in the most easier way. She is the best teacher for Science and maths.
The entire syllabus of both Physics and Chemistry will be completed, with special emphasis on simplification of concepts, solving numericals, writing of Chemical Formulae, balancing Chemical Equations.Practise questions will be done, doubts clarified, assessment tests in order to test the knowledge and progress of the student from time to time.
PPP Approach to make the students understand the topics. Unified Approach to make the students to work independently and collaboratively. Heuristic Approach to make the students to understand theories through lab practical. Use few other contemporary approaches not limited to Brain Storming, Mind Mapping, Concept Mapping, Snowballing etc., Providing supervision & consultation for students, in the form of academic advising, students’ support, recruitment, courses and programs. Also, participating in student & staff social and cultural activities.
I have the experience of teaching the above subjects for the last 20 years. I have also received a letter of commendation for valuable contribution to teaching in C B S E School by H R D Ministry signed by Honorable Minister Smriti Irani in the year 2015. I have taught in different schools i.e. DPS Bokaro, D P S Bhagalpur as guest teacher of Social Science for Pre foundation course preparing the students for N T S E and other competitive examinations under the Kota based Institute RAO IIT ACADEMY under RAO EDUSOLUTIONS PVT. LTD., Head Office at Mumbai . With regards to my teaching methodology I have always tried to make my subject and its contents easier to be delivered amongst my students so that they consider it an interesting subject and they could make it useful in their day to day life as the aim of education is to make a good human being and a responsible global citizen. I have qualified C T E T conducted by C B S E and participated in different workshops conducted by schools under C B S E and my school too
Best teacher for social studies. He has very good teaching experience. The way of his teaching is very good.
As an educator with 18 years of experience, I have always been passionate about teaching. I hold a B.Ed and M.Sc. degree. Throughout my career, I have worked in various schools, including Assembly of God Church School and Lucknow Public College. After gaining extensive experience in the classroom, I decided to open a tuition centre at my home. I wanted to provide a more personalised learning experience for my students. It was a great success, and I am proud that my students achieved excellent results. Eventually, I took my teaching to the next level and joined UrbanPro. I now offer online tutoring services for students from classes 6-9 in Maths and Science. My online tutoring sessions are 1 hour long, and I always prepare a lesson plan in advance. Interactive sessions are the key to effective learning, and I ensure that my students are engaged and actively participating in the class. I do not rely on rote learning and instead provide my students with detailed notes and question-and-answer sessions to ensure that they thoroughly understand the concepts. Education is not just about getting good grades but also about developing critical thinking and problem-solving skills essential for success in life. My experience in the teaching field has been rewarding, and I am grateful for the opportunity to have had a positive impact on the lives of so many students. As an educator, I aim to inspire and motivate my students to reach their full potential.
She was one of the best teachers of our school. Very friendly, polite and diligent methods of teaching!
Download free CBSE - Class 9 Science Sound Exercises worksheets
Download Now